B-36
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform dot1x
debug platform dot1x
Use the
debug platform dot1x
privileged EXEC command to enable debugging of IEEE 802.1x events.
On stacking-capable switches, this command enables debugging of stack-related IEEE 802.1x events.
Use the
no
form of this command to disable debugging.
debug platform dot1x
{
initialization
|
interface-configuration
|
rpc
}
no debug platform dot1x
{
initialization
|
interface-configuration
|
rpc
}
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
undebug platform dot1x
command is the same as the
no debug platform dot1x
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the
session
switch-number
privileged EXEC command. Then enter the
debug
command at the command-line
prompt of the stack member. You also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
initialization
Display IEEE 802.1x-authentication initialization sequence debug
messages.
interface-configuration
Display IEEE 802.1x interface configuration-related debug messages.
rpc
Display IEEE 802.1x remote procedure call (RPC) request debug
messages.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are enabled.
