Solaris
Use
lpadmin
command to register the default printer.
# lpadmin -d PrinterName
To inhibit the banner sheets output, change the value of
nobanner=no
to
nobanner=yes
that includes in
the file corresponding to the printer name in
/etc/lp/interfaces/
.
The printer registered by UNIX filter must not be changed by admintool.
When
Content types: postscript
is displayed by typing
lpstat -p
printername
- l
, it's necessary
to delete the printer and reinstall.
To install UNIX filter into the default directory (
/usr/local/dellbin3115
), it's necessary to create
/usr/local
directory in advance.
HP-UX
The multifunction printer to specify as an output printer must be registered in your system. To register
an output printer, use
sam
command and so on. See the HP-UX related manual for details.
To install UNIX filter into the default directory (
/usr/local/dellbin3115
), it's necessary to create
/usr/local
directory in advance.
Linux
To install UNIX filter into the default directory (
/usr/local/dellbin3115
), it's necessary to create
/usr/local
directory in advance.
During Printing
Pay attention to the following points during printing.
Using lp/lpr Command (Linux/Solaris/HP-UX)
If an option is specified incorrectly, no error message will be output. If printing is not executed after
the
lp
command is executed, activate each utility individually and error messages will be output.
(Using Solaris, the error message is displayed on the screen. Using Linux, the error message is written
into the error log file specified by printcap.)
In text printing, the environmental variable
TXT2PS2OPTION
will be ignored.
In text printing, if a BS code is found at the beginning of a line, the print position of the next character
will be on the left of the beginning of the line.
In text printing, when there are multiple tab codes in one line, the positions of tab may be off due to
Содержание 3115CN
