Software
Crestron
D3 Pro
™
When you select a button model, each event will be shown as a separate tab. You
assign actions to an event by double clicking inside the tabbed area. The button
model shown below provides two events, and thus two “event” tabs, for Press and
Press 2, in addition to a Feedback tab.
A
BOUT
L
EARNABLE
L
IGHTING
Two of the button models described in this section, Toggle and Single Press, provide
a "learnable lighting" option that allows the end user to dynamically change and re-
save lighting presets. To enable this feature select the
Learnable Lighting
check box
in Button Properties. Learnable Lighting mode is described in detail later in this
section, on page 67.
You can choose from the following button models:
S
INGLE
P
RESS
The Single Press button model provides different events depending on whether the
Learnable Lighting
check box is selected. If you do not enable learnable lighting,
the single press button provides one programmable event:
Press
.
In learnable lighting mode the single press button provides one programmable event:
Tap, and one non-programmable event:
Hold
. Here the event names change because
tapping the button (pressing and releasing) is different from pressing and holding the
button. In learnable lighting mode, the end user can dynamically change and re-save
the lighting levels programmed to the Tap event (see Learnable Lighting on page 67).
The Single Press button model triggers one or more actions when pressed. For
example, the button press might fade the lights in a room to a certain level and close
the drapes. Each time the button is pressed, the same actions are executed.
By default, this button model generates momentary feedback. Suggested feedback for
lighting: ON when ALL LIGHTS are at PRESET level.
50
•
Crestron D3 Pro™
Reference Guide – DOC. 5998a
