Cisco DS-C9216I-K9, Руководство по настройке

Страница: 398 / 436

30-10
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
OL-7753-01
Chapter 30 Monitoring Network Traffic Using SPAN
Default SPAN Settings
Figure 30-7 Fibre Channel Analyzer Using a Single SD Port
To use this setup, the analyzer should have the capability of distinguishing ingress and egress traffic for
all captured frames.
Default SPAN Settings
Table 30-1 lists the default settings for SPAN parameters
Remote SPAN
The Remote SPAN (RSPAN) feature enables you to remotely monitor traffic for one or more SPAN
sources distributed in one or more source switches in a Fibre Channel fabric. The SPAN destination (SD)
port is used for remote monitoring in a destination switch. A destination switch is usually different from
the source switch(es) but is attached to the same Fibre Channel fabric. You can replicate and monitor
traffic in any remote Cisco MDS 9000 Family switch or director, just as you would monitor traffic in a
MDS source switch.
The RSPAN feature is nonintrusive and does not affect network traffic switching for any SPAN source
ports. Traffic captured on the remote switch is tunneled across a Fibre Channel fabric which has trunking
enabled on all switches in the path from the source switch to the destination switch. The Fibre Channel
tunnel is structured using trunked ISL (TE) ports. In addition to TE ports, the RSPAN feature uses two
other interface types:
Cisco
MDS 9000
switch
fc1/1
RX
TX
TX
TX
TX
85653
Dropped* * The egress (TX) traffic coming out from
the analyzer ports will be dropped.
SD Port
fc2/1
Bidirectional source in session 1 - SD port fc2/1
1
FC Analyzer
Storage
device
Table 30-1 Default SPAN Configuration Parameters
Parameters Default
SPAN session Active.
If filters are not specified SPAN traffic includes traffic through a specific
interface from all active VSANs.
Encapsulation Disabled.
SD port Output frame format is Fibre Channel.