Cisco DS-C9216I-K9, Руководство по настройке

Страница: 248 / 436

22-2
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
OL-7753-01
Chapter 22 Configuring IP Services
Traffic Management Services
Traffic Management Services
In-band options are compliant with and use the RFC 2625 standards. An NMS host running IP protocol
over a FC interface can access the switch using the IPFC functionality. If the NMS does not have a Fibre
Channel HBA, in-band management can still be performed using one of the switches as an access point
to the fabric.
Figure 22-1 Management Access to Switches
Configuring the Ethernet Management Port
The management port on the switch allows multiple simultaneous Telnet or SNMP network management
sessions. You can also configure the supervisor module Ethernet interface and VSAN interfaces as
management ports. This section focuses on the Ethernet management port (mgmt0). You can remotely
configure the switch through the management port. To configure a connection remotely, you must
configure the IP parameters (IP address and subnet mask) from the CLI so that the switch is reachable.
Before you begin to configure the management interface manually, obtain the switch IP address and IP
subnet mask. Also make sure the console cable is connected to the console port.
CLI
GUI
DNS server
IP
network
Router
IPaddress
172.16.1.1
Telnet or
SSH
SNMP
Management LAN
(Ethernet connection)
Switch 2 Switch 3
Switch 1
mgmt 0
VSAN 1
(IP address:
172.16.1.2) (IP address:
10.0.0.1)
(IP address:
10.0.0.2)
Fibre
Channel
network
Storage
array
Server
Disk
subsystem
Console
connection
In-band
management
subnetwork
Out of band
management
subnetwork
79936