Cattron DYNAGEN TOUGH Series TE410, Руководство пользователя

Страница: 102 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
102
9M02-9249-A001-EN
Revision A
Name Range Default Description
Auto Rated >
1Ph 3-Wire 5 ~ 5000 A
in 1 A increments 100 A Rated Amps when using the AC Voltage
Select inputs.
Auto Rated >
3-Phase (1) 5 ~ 5000 A
in 1 A increments 100 A
Auto Rated >
3-Phase (2) 5 ~ 5000 A
in 1 A increments 100 A
Auto Rated >
3-Phase (3) 5 ~ 5000 A
in 1 A increments 100 A
Auto Scaling >
1Ph 3-Wire 0.500 ~ 2.500
in 0.001 increments 1.000 Scaling Factor when using the AC Voltage
Select
inputs.
Auto Scaling >
3-Phase (1) 0.500 ~ 2.500
in 0.001 increments 1.000
Auto Scaling >
3-Phase (2) 0.500 ~ 2.500
in 0.001 increments 1.000
Auto Scaling >
3-Phase (3) 0.500 ~ 2.500
in 0.001 increments 1.000
Dummy Load [Menu] See the Dummy Load section.
Basic Alarm [Menu] See the Basic Alarms section.
IDMT Protect Disable
Breaker Trip
Shutdown Trip
See the IDMT section.
IDMT Settings [Menu]
Imbalance Mode Disable
Breaker Trip
Shutdown Trip
See the Load Imbalance section.
Imbalance Set [Menu]
Break Trip Fail Disable
Enable
Disable Shuts down the generator if the generator
circuit breaker fails to trip.
If the 62 switched output is active - due to
IDMT or Load Imbalance - and if after 10
seconds the measured generator current is
still above 10% of the Rated Current, the
generator will shut down.
5.7.3.1 Basic Alarms
The controller can give a warning and/or shut down on over current. If IDMT is enabled, then it overrides the
High Failure shutdown, but the warning is still active.