Cattron DYNAGEN TOUGH Series TE410, Руководство пользователя

Страница: 100 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
100
9M02-9249-A001-EN
Revision A
Name Volt Select 2 Input
Genset Voltage > Auto Nominal These settings correspond to the
“Nominal Volts” setting under the AC
Monitor > Genset Voltage menu.
Genset Voltage > Auto Scaling These settings correspond to the
“Scaling Factor” setting under the AC
Monitor > Genset Voltage menu.
Genset Voltage > Auto Single Only applies when voltage source is set to 1-Phase 3-Wire. This
determines the phases from which the single phase voltage is read:
A-C or A-B.
Genset Current > Auto Rated These settings correspond to the
“Rated Amps” setting under the AC
Monitor > Genset Current menu.
Genset Current > Auto Scaling These settings correspond to the
“Scaling Factor” setting under the AC
Monitor > Genset Current menu.
5.7.2 Generator Frequency
Generator AC frequency display on the controller is enabled when the Generator Voltage is not set to Disable.
The following settings are used to configure the controller
’s responses to frequency measurements.
Frequency Settings (in AC Monitor > Genset Freq)
Name Range Default Description
Freq. Source 50 Hz System
(50 Hz)
60 Hz System
(60 Hz)
Auto Selection
60 Hz
System This is the wiring configuration of the
generator. Selecting Auto Selection will
use the
RPM /
Frequency Select
input to determine which frequency is
used.
This setting is used by the following
setpoints. It does not affect the display of
AC Frequency.
Setpoints > Low Warn
(Under-Frequency
Warning) Disable
20 ~ 99%
in 1% increments
90% Reading at which a warning occurs.
Setpoints > Low Fail
(Under-Frequency
Failure) Disable
20 ~ 99%
in 1% increments
85% Reading at which a failure occurs.
Setpoints > High Warn
(Over-Frequency
Warning) Disable
101 ~ 150%
in 1% increments
110% Reading at which a warning occurs.
Setpoints > High Fail
(Over-Frequency
Failure) Disable
101 ~ 150%
in 1% increments
115% Reading at which a failure occurs.
5.7.2.1 RPM / Frequency Select
The controller has the ability to change between Primary RPM / 60 Hz and Secondary RPM / 50 Hz through the