Cattron DYNAGEN TOUGH Series TE410, Руководство пользователя

Страница: 66 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
66
9M02-9249-A001-EN
Revision A
Name Range Default Settings Description
Sensor Type DAT DAH*
VDO 250F*
(custom sender)**
Close =
Open =
Close =
Open =
DAT DAH Select the sender that is connected to the
Signal Source above. If using a switch, select
the action that should occur when the switch
is active.
*These are preprogrammed into the
controller and cannot be changed.
-
DAT DAH supports all Datcon type
DAH (high range) temperature
sensors such as 02022-00
-
VDO 250F supports the VDO 323-
420 or equivalent temperature sensor
DAT DAH and VDO 250F can only be used if
the Signal Source is set to Port A, C or D. To
use on other ports, store as a custom sender
table using the RapidCore Configurator
software.
**A custom table can be created using the
RapidCore Configurator Software. The text
(custom sender) will be replaced with the
custom text you choose when creating the
sender.
+The switch must close to ground.
Trim Offset -50.0 ~ 50.0 °F
(-27.8 ~ 27.8 °C) 0.0 °F Calibrate a sensor by using the offset to
correct errors. Only applies if Sensor Type
has been set to a sender.
Setpoints > Bypass
Time 0 ~ 90 s 30 s Amount of time to bypass warnings and
failures after engine has started.
Setpoints > Low
Warn (Low Warning) Disabled
32 ~ 200 °F
(0 ~ 93.3 °C)
Disabled Reading at which a
“Low Engine Temp”
warning occurs. Displays
‘Low Engine Temp’
on the screen. Only applies if Sensor Type
has been set to a sender. Monitored globally
including Off and Auto Mode.
Setpoints > High
Warn (High
Warning) Disabled
50 ~ 300°F
(10 ~ 148.9 °C)
200 °F Reading at which a
“High Engine Temp”
warning occurs. Only applies if Sensor Type
has been set to a sender. Only monitored in
the Run Mode.
Setpoints > High
Fail (High Failure) Disabled
50 ~ 300°F
(10 ~ 148.9 °C)
220 °F Reading at which a
“High Engine Temp”
failure occurs. Only applies if Sensor Type
has been set to a sender. Only monitored in
the Run Mode.
Note: All temperature settings are entered in terms of Fahrenheit.