Cattron DYNAGEN TOUGH Series TE410, Руководство пользователя

Страница: 61 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
61
9M02-9249-A001-EN
Revision A
Name Active Mode Description
Off Mode (Not In
Auto) Off Active when the controller is in the Off Mode.
Idle Mode Idle Mode Active when the controller is in Idle Mode. For example,
when the idle switched input is active or during warmup
and cooldown if warmup idle and cooldown idle settings
under Timers > Engine Logic are enabled.
Battle Mode Battle Mode Active when Battle Mode switched input is active.
System OK
(System Ready) Auto, Run Active when the controller is in the Auto and Run Modes
and no warnings or failures are present.
Delay to Start Delay to Start Timer Active when the Delay to Start timer is active.
Glowplug Preheat, Midheat,
Postheat Active during the Preheat, Midheat and Postheat timers.
Warmup Warmup Timer Active in Run Mode after Warmup Timer has expired. Is not
active in the cooling down state or other states. Typically
used to apply load to the engine only after it has warmed
up and to remove the load on cooldown.
Cooldown Cooldown Timer Active when Cooldown Timer is active.
Engine Running Running Active after crank success.
Exercising Exercise Timer Active during the engine exercising cycle.
Batt. Recharge
(Battery Recharge) Battery Recharge Timer Active during the battery recharge cycle.
Maintenance
(Maintenance
Required) Global Active when Maintenance timer has expired. If the timer
has expired when the controller is in the Run Mode, the
output does not turn on until the controller enters the Off or
Auto Mode. See the
Maintenance section.
LowBat InCrank
(Low Battery
During Cranking) Cranking Active when Low Battery During Cranking warning is
displayed.
Aux Sensor 1 Auxiliary Settings
Dependent Active dependent upon settings in the Auxiliary Sensors
section.
Aux Sensor 2
Aux Sensor 3
Aux Sensor 4
Force Regen User Controlled When user triggers a Force Regeneration, output is active
for 20 seconds then switches off.
Regen Inhibit User Controlled When user triggers a Regeneration Inhibit, output is active
for 20 seconds then switches off.
Common Failure Any Failure Active when any failure occurs.