Canon iR7086, Руководство по обслуживанию

Страница: 77 / 735

Chapter 2
2-19
F-2-57
12) Disconnect the connector [1], and release the locking lever [2] of the pre-
transfer charging assembly; then, remove the pre-transfer charging as-
sembly [3].
Clean the pre-transfer charging assembly using alcohol.
F-2-58
13) While keeping it unlocked, fit in the primary charging assembly, and
connect the connector.
14) While keeping it unlocked, fit the pre-transfer charging assembly in
place, and connect the connector.
15) Mount the double-feeding detection PCB (reception).
16) Mount the primary charging assembly front cover and the pre-transfer
charging assembly cover.
17) Close the front cover.
2.2.8 Mounting the Developing Assembly
0010-8950
iR7105 / iR7095 / iR7086 / iR7095P
1) Open the manual feed cover.
2) Remove the tape [1]; then, remove the hopper supply mouth cover [2].
F-2-59
3) Holding the developing assembly [1] as shown, fit it in place in the ma-
chine.
F-2-60
4) Connect the connectors [1], [2].
Check to make sure that the solvent on the primary charging assembly and
the pre-transfer charging assembly is fully dry.
Check to be sure that the one-way arm [1] of the pre-transfer charging
assembly is on the eccentric cam [2].
[1]
[2] [3]
[1]
[2]
[3]
When mounting the developing assembly, take care not to hit against the
developing cylinder [2].
Check to be sure that the connector will not become disconnected. Poor
contact will lead to blank prints.
[1]
[2]
[1]
[2]
[1]
[2]