Canon iR7086, Руководство по обслуживанию

Страница: 94 / 735

Chapter 2
2-36
F-2-149
3) Move the cassette guide assembly (front) [1] to the front or the rear to
make adjustments.
- move the guide plate to the rear to decrease the horizontal registration
(left margin).
- move the guide plate to the front to increase the horizontal registration
(left margin).
F-2-150
4) heck to make sure that the horizontal registration (left/right margin) on
prints using the front deck (left/right) is 2.5 +/-1.5 mm.
F-2-151
[1] Paper movement
5) Tighten the 4 screws you loosened in step 2).
6) Put the front deck (left/right) back in place.
<Manual Feeder Tray>
1) Move the side guide plate [1] to the center, and loosen the 2 manual feeder
tray mounting screws [2]; then, adjust the position of the manual feeder
tray.
F-2-152
<Duplexing Transport Unit>
1) Make the following selections in service mode: COPIER > ADJUST >
FEED-ADJ > ADJ-REFER so that the image margin on the 2nd side will
be as indicated.
2) Exit the service mode.
- if the margin is too large, decrease the setting of ADJ-REFER (a change
of 10 will decrease the margin by 1 mm).
- if the margin is too small, increase the setting of DJ-REFER (a change
of 10 will increase the margin by 1 mm).
W1=2.5 +/-2.0 mm
F-2-153
[1] Paper movement
2.2.23 Adjusting the Lead Edge Registration
0011-3857
iR7105 / iR7095 / iR7086
1) Make the following selections in service mode so that the image margin
will be as indicated: COPIER > ADJUST > FEED-ADJ > REGIST.
2) Exit the service mode.
- if the margin is too large, increase the setting of REGIST (a change of
10 will decrease the margin by 1 mm).
- if the margin is too small, decrease the setting of REGIST (a change of
10 will increase the margin by 1 mm).
Lf=4.0+1.5/-1.0
F-2-154
2.2.24 Adjusting the Lead Edge Registration
0012-2061
iR7095P
1) Make the following selections in service mode so that the image margin
will be as indicated: COPIER > ADJUST > FEED-ADJ > REGIST.
2) Exit the service mode.
- if the margin is too large, increase the setting of REGIST (a change of 10
will decrease the margin by 1 mm).
- if the margin is too small, decrease the setting of REGIST (a change of 10
will increase the margin by 1 mm).
Lf=4.0+1.5/-1.0
[1]
[1]
[1]
image
L1
[1]
[2]
[1]
image
W1
[1]
0
2
4
6
8
10
0
2
4
6
8
10
Lf