Canon iR7086, Руководство по обслуживанию

Страница: 292 / 735

Chapter 7
7-46
F-7-131
5) From the cut-off of the shielding plate [1], free the felt holder [2].
6) Pick the wire cleaner with a pair of fine-tipped pliers, and free the hook
with your finger.
F-7-132
7.10.19.4 Stringing the Charging Wire
0010-8939
iR7105 / iR7095 / iR7086
As a rule, the charging wire (except the grid wire) may be strung in the same
way for all charging assemblies. The following uses the primary charging as-
sembly as an example:
1) Remove the 2 screws [1], and detach the shielding plate (left, right) [2] of
the charging assembly.
To prevent deformation (slack) of the primary charging assembly, be sure
to work on the left and right shielding plates separately. (Do not loosen
the screw for the left/right shielding plate.)
2) Remove the wire cleaner.
F-7-133
For other charging assemblies, remove the lid (2 pc.)
3) Free a length of about 5 cm from a charging wire reel (wire dia. of 0.06
mm), and form a loop at the end about 2 mm in diameter.
F-7-134
MEMO:
To form a loop, wind the charging wire once around a hex key, and twist the
key 3 to 4 times.
4) Cut the end (excess) for the twisted charging wire.
5) Hook the loop on the stud.
6) Hook the charging wire on the charging wire positioner at the rear, and
hook the charging wire tension spring on the charging wire, and twist it.
F-7-135
7) Cut the excess of the charging wire with a nipper.
8) Pick the end of the charging wire tension spring with tweezers, and hook
it on the charging wire terminal. In the case of the pre-transfer charging
assembly, hook the spring at the front.
F-7-136
Be sure of the following:
- The charging wire is free of bends and twists.
- The charging wire is in the bottom of the V-groove of the charging wire
positioner.
F-7-137
9) Fit the cushion to the front of the charging wire. (except for primary charg-
ing assembly)
10) Mount the shielding plate (left, right).
For other charging assemblies, fit the lid (2 pc.).
After stringing the charging wire of each charging assembly, check to make
sure that the length of the tension spring is as follows:
[1]
[2]
[1]
[5]
Cut off
Cut off
[2] [1] [1]
Stud
Reel
Charging wire
Charging
terminal
(front) (rear)
Grid side
(correct) (wrong)