Canon iR7086, Руководство по обслуживанию

Страница: 288 / 735

Chapter 7
7-42
F-7-106
4) Remove the screw [1], and detach the fixing plate [2]; then, disconnect the
connector [3], and detach the transfer/separation charging assembly [4].
F-7-107
Points to Note When Mounting
- The transfer/separation charging assembly is equipped with a positioning
boss on its front and rear.
When mounting the assembly, be sure to hook the bosses on the cut-offs
in the stay.
- If the charging assembly cleaner is on the front side, the home position de-
tecting microswitch can become damaged; be sure to set the charging
cleaner at the center.
F-7-108
F-7-109
7.10.15 Pre-Transfer Exposure LED
7.10.15.1 Removing the Pre-Transfer Exposure LED
0010-8878
iR7105 / iR7095 / iR7086
1) Slide out the pre-transfer charging assembly.
When placing the removed pretransfer charging assembly, be sure to take
care not to subject the LED to impact.
2) Turn over the pre-transfer charging assembly, and remove the 3 screws [1]
found on the bottom; then, detach the LED cover [2].
F-7-110
3) Disconnect the connector [1], and remove the pre-transfer exposure LED
[2].
F-7-111
7.10.16 Separation Claw/Separation Claw Drive Assembly
7.10.16.1 Separation Claw/Separation Claw Drive
Assembly
0010-8880
iR7105 / iR7095 / iR7086
1) Open the front cover.
2) Take out the process unit.
3) Remove the E-ring [1], and slide out the separation claw holder shaft [2]
to the front to detach the separation holder [3].
F-7-112
4) Remove the spring [1], and detach the separation claw [2].
[1] [2]
[1]
[2]
[3]
[4]
Boss
Boss
Boss
Boss
[1]
[2]
[1]
[2]
[2]
[3]
[1]