Encore Presentation System • User’s Guide
303
7. Operations
Working with Layers
tçêâáåÖ=ïáíÜ=hÉóë=áå=jáñ=jçÇÉ
In
Mix Mode
, a mixer’s layers are ganged together. Both Keys can be perfectly co-located
on screen (
Mix Source
mode), or both can operate independently (
Swap
mode), but only
one layer can be on Program at a time.
Use the following steps to work with Keys in
Mix Mode
.
1.
On the
Destination Bus
, select the desired destination(s).
2.
In the
Layer Control Section
, press the desired layer button:
~
The layer button blinks to indicate that it is active for modification.
~
In the
Source Selection Bus
, the source assigned to the layer blinks.
~
On Preview, the raster box for the selected layer blinks (even if it is
hidden under another layer).
3.
In the
Layer Function Section
, press
Key
to display the
Key Menu
.
4.
In the
Transition Functions Section
, select the desired
Mix Mode
:
~
To co-locate the mixer’s layers, press
Mix Source
.
~
To locate the mixer’s layers independently, press
Swap
.
~
To toggle sources, enable
Toggle
.
5.
On the
Source Selection Bus
, select the desired (new) key source. The button
blinks to indicate that it is selected, and the source appears on Preview.
6.
Adjust the Key as required. Refer to the “
Modifying Keys
" section on page 304
for details.
7.
Transition the setup to Program. Refer to the “
Working with Transitions
" section
on page 320 for details.
8.
Repeat the procedure from step
1
for the next transition.
rëáåÖ=`ìí=C=cáää
In any mixer, a
Cut + Fill
key is one in which the hole-cutting information is provided by a
Key on
Layer B
, while the fill information is provided by an effect on
Layer A
(either a PIP
or a Key). In this mode, the two layers can be manipulated independently or joined
together using the “
Join
” mode.
Use the following steps to create a
Cut & Fill
Key:
1.
On the
Destination Bus
, select the desired destination(s).
2.
Identify the mixer in which you want to create the
Cut & Fill
Key. All subsequent
steps apply to that mixer.
3.
In the
Layer Control Section
, turn the
Split
button
ON
in the mixer.
4.
Press the
Layer A
button, and select the "fill" type — either PIP or Key. Typically,
the fill is a PIP. This video will appear "inside" the key hole.
5.
On the
Source Selection Bus
, select the "fill" video source.
6.
Press the
Layer B
button and select
Key
to display the
Key Menu
.
7.
On the
Source Selection Bus
, select the "cut" video source.
Note
Cut + Fill
keys can only be selected on Layer B when the
Split Mode
is enabled.
Содержание Encore
