Barco Encore, Руководство пользователя

Страница: 317 / 404

Encore Presentation System • User’s Guide 317
7. Operations
Working with Live Modes
tçêâáåÖ=ïáíÜ=iáîÉ=jçÇÉë
The following topics are discussed in this section:
•
Using Live Switch Program/Preview Mode
•
Using Live Switch Source Mode
•
Live Mode Source Timing
rëáåÖ=iáîÉ=pïáíÅÜ=mêçÖê~ãLmêÉîáÉï=jçÇÉ
The Live Switch Program/Preview Mode turns both rows of the Source Selection Bus
into two buses, both of which can be used to route sources into PIPs and Keys:
•
The top row is the Program bus. When you select sources here, you perform live
"cuts" directly on Program.
•
The bottom is the Preview bus. When you select sources here, you can "cut" or
"transition" them to Program.
„
Use the following steps to utilize the Live Switch Program/Preview Mode :
1. On the Destination Bus , enable the desired destination(s).
2. On Preview , select the one layer that you want to remain enabled when you enter
the live mode. All other Preview layers will be cleared.
3. Press Shift + Program/Preview . The Program/Preview button lights to indicate
that the mode is enabled.
~
When you first enter the mode, all layers on Preview (except the
selected one) are cleared. All layers on Program remain as is.
~
The top Program bus is now mapped with the same inputs as the bottom
Preview bus, but only half of your inputs are available:
• On the Controller SC , inputs 1 - 6 and shifted inputs 7 - 12 are
available (but they are mapped to the Preview row). Inputs 13 -
24 are not available.
• On the Controller LC , inputs 1 - 16 and shifted inputs 17 - 32
are available (but they are mapped to the Preview row). Inputs
33 - 64 are not available.
4. With the mode enabled, there are several ways you can switch and transition:
~
Select a layer and a function (PIP or Key). On Preview , select (pend)
the desired source, then perform the desired transition. The source
transitions to
Program .
~
Select a layer and a function (PIP or Key) that is not already on
Program . Its "last selected" source appears on Preview . Select a
source directly on Program to immediately cut that layer to Program .
~
Select a layer already on Program . Select a source on Preview or
Program to immediately cut that source into the layer.
~
Use the Clear Layer function in the normal way to transition layers off of
the Program bus.
5. To clear the entire mode, press Shift + Program/Preview . The button turns off,
and the entire Source Selection Bus is returned to its normal functionality.
Program
Preview