![background image](http://html1.mh-extra.com/html/barco/encore/encore_manual_3871756079.webp)
Encore Presentation System • User’s Guide
79
3. Hardware Installation
Installation
b.
When
Internal
routing is used, connect Analog sources to inputs
1
-
8
on
the HD-15 connectors, and SDI sources to BNC inputs
1
and
2
. During
setup, these patches will be defined using the
Input Patch Menu
.
11. Output Connections
— all output monitor and projector connections originate
from the “
top stack
” Processors:
a.
On each “top stack” Processor, connect the analog or digital
Preview
Output
to the input of the associated Preview Monitor.
b.
On each “top stack” Processor, connect the analog or digital
Program 2
Output
to the input of the associated Program Monitor.
c.
On each “top stack” Processor, connect the analog or digital
Program 1
Output
to the input of the associated projector.
d.
(Optional) If your Processors are configured with the HD/SDI output,
connect the “top stack”
Program Out HD/SDI
connector to an SDI or
HDTV monitor, or to the proper video distribution equipment.
e.
If you elect to output in an interlaced format (e.g., 1920 x 1080i), connect
each top stack’s
H Sync Output
signal (located on the
Program 2 Out
Analog
connector) to the
Genlock
input on the bottom stack.
12. Aux Destinations
— you can configure three types of Aux destinations:
Aux
(monitors),
ImagePRO Aux
and
PresentationPRO-II Aux
. Refer to Appendix D,
“
Working With Destinations
” on page 367 for interconnection details.
13. Power Connection
— connect AC power cords to all Encore and peripheral
equipment, and then to AC outlets.
14. Tally Connection
— the Controller provides one 25-pin D connector for issuing
“relay closure” commands to external devices. Eight circuits are provided. In
Appendix A, refer to the “
Tally Connector
” section on page 351 for details.
15. System ID
— Using the
Unit ID Selector
:
a.
On the first stack, set the ID of the bottom stack Processor to
1
. Set the
ID of the top stack Processor to
2
.
b.
On the second stack, set the ID of the bottom stack Processor to
3
. Set
the ID of the top stack Processor to
4
.
16. Power On
— all power on instructions are covered in Chapter 6.
With all connections made, continue with Chapter 4, “
Controller Orientation
” on page 97.
Note
This output will only work if the selected output resolution is a
valid SDI or HD/SDI format.
Note
Using a (customer supplied) VGA to 5xBNC breakout cable,
the
H Sync Output
line is typically a white or gray cable.
Important
In each stack, the ID of the bottom stack Processor must
always
be lower than the ID of the top stack Processor.
Содержание Encore
