Barco Encore, Руководство пользователя

Страница: 365 / 404

Encore Presentation System • User’s Guide 365
`K==réÖê~ÇáåÖ=pçÑíï~êÉ
Ethernet Upgrade Method
8. In the dialog, enter Controller’s IP address ( 192.168.0.1 ), and enter the default
port number: 3000 .
9. Click the Connect button. If the connection is successfully, the message
“ Connect via Ethernet successful ” appears in the Flash Loader’s Status Bar . If
you cannot connect, refer to the “ Troubleshooting Ethernet Communication ”
section on page 365.
10. To upload files to the Controller, click " Open script file to read and upload ."
11. In the dialog, select " Complete_Load.sld " and click Open . The Encore menu
should immediately display the " System in LOADER MODE " message.
12. It takes several minutes to load the flash memory. When complete, the Flash
Loader utility displays the “
Upload Complete ” message. Click OK to continue.
13. Cycle power on the Controller, and exit the Flash Loader utility.
14. On the Controller, perform a factory reset. In Chapter 6, refer to the “ Return to
Factory Default ” section on page 246 for instructions.
15. At this point, the System Status Menu will display the “ Please Upgrade ”
message, because an incompatibility exists between code versions in the
Controller and the Video Processors.
To download code from the Controller to all target devices (including Video
Processors, ScreenPRO-II units and PresentationPRO-II), follow the instructions
in the “
Downloading Code ” section on page 245.
16. On the Controller, verify that the new software has been loaded correctly:
~
In the System Keypad , press SYSTEM to display the System Menu .
~
Press { SW VER } to display the Software Version Menu .
qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå
„
Use the following steps to determine the IP address of the Controller, and establish
proper communications:
1. Turn on the Controller. In the System Keypad :
a. Press SYSTEM to display the System Menu .
b. Press { NETWORK SETUP } to display the Network Setup Menu .
2. Make a note of the IP address.
3. Attempt to ping the Controller as follows:
a. Connect the Controller’s Ethernet port to a Switch.
b. Connect the Ethernet Switch to your PC. A totally “local” network is
recommended, without IP connections to the outside world.
c. Turn on the PC or laptop.
d. Open a command prompt window on the PC. Click Start > Programs >
Accessories > Command Prompt .
Note The Controller’s default IP address is 192.168.0.1 . The Video
Processor’s default IP address is 192.168.0.10 .