Barco Encore, Руководство пользователя

Страница: 318 / 404

318 Encore Presentation System • User’s Guide
7. Operations
Working with Live Modes
Please note the following points regarding the Live Switch Program/Preview Mode :
•
When switching directly on Program , the Controller uses a predefined set of
rules. Refer to the " Live Mode Source Timing " section page 319 for details.
•
Program LEDs are disabled on the Source Selection Bus only — but not in the
Layer Control Section . The only exception is that a blinking Red LED on
Program still indicates that the associated mixer is set to Mix Mode .
•
If a layer is on Preview only, the PIP or Key can be sized and positioned.
•
The Split and Mix modes operate in the normal manner.
•
You can program a "move" with a source already on Program. When you press
Move Setup , you can move the raster box on Preview and choose the
"destination" location and size.
•
When using the mode in conjunction with Presets , the following rules apply:
~
When learning Presets, they will still be learned from Preview.
~
When recalling Presets, they will still be recalled to Preview.
~
A Preset remembers if the Live Switch Program/Preview Mode was
active at the time it was learned. Upon Preset recall, the mode is
enabled automatically.
•
The Live Switch Program/Preview Mode is automatically disabled when you
change destinations.
rëáåÖ=iáîÉ=pïáíÅÜ=pçìêÅÉ=jçÇÉ
The Live Switch Source Mode turns both rows of the Source Selection Bus into a live
“Program” bus. For a selected layer, when a source button is pressed, the layer switches
to the new source. This is a "cuts only" mode — without any transitions.
„
Use the following steps to utilize the Live Switch Source Mode :
1. On the Destination Bus , enable the desired destination(s).
2. On Preview , select the one layer that you want to remain enabled when you enter
the live mode. All other Preview layers will be cleared.
3. Press Shift + Source . The Source button lights to indicate the mode is enabled.
~
When you first enter the mode, all layers on Preview (except the
selected one) are cleared. All layers on Program remain as is.
~
Both rows of the Source Selection Bus are now a live Program Bus ,
and all of your inputs are available.
4. With the mode enabled, there are several ways you can switch:
~
Select a layer and a function (PIP or Key) that is not already on
Program . Its "last selected" source appears on Preview . Size and
position the layer in the normal way. Select a source to immediately cut
that layer to
Program .
~
Select a layer already on Program . Select a source to immediately cut
that source into the Program layer.
~
Use the Clear Layer function to transition layers off of the Program bus.
Source
Note When you press Clear Layer, the Live Switch Source Mode
is automatically cancelled.