Barco Encore, Руководство пользователя

Страница: 266 / 404

266 Encore Presentation System • User’s Guide
6. System Setup
Projector Setup
mêçàÉÅíçê=pÉíìé
Encore system setup: Step 15
S
Prerequisites — Ensure that you are familiar with the following:
~
Test Pattern Menu . In Chapter 5, refer to the “ Test Pattern Menu ”
section on page 153.
~
Wide Screen Menu . In Chapter 5, refer to the “ Wide Screen Settings
Menu ” section on page 154.
~
Configurator Application . You can use the Configurator application to
assist with wide screen setup. The software is available via download
from the Barco website, or contact
Barco Technical Support . In
Appendix B, refer to the “ Contact Information ” section on page 358.
In this section, you will set up your projectors for both single screen and widescreen
destinations. The following procedures are provided:
•
Single Screen Projector Setup
•
Wide Screen Projector Setup
páåÖäÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé
„
Use the following steps to set up a projector for a single screen destination.
1. In the System Keypad , press OUTPUT to display the Output Menu .
2. On the Destination Bus , select the destination whose projector you want to
configure.
3. Press
{
TEST PATTERN
}
to display the Test Pattern Menu .
4. On the Output Monitor line, select the output(s) on which you want a test pattern
to appear — All , Preview , Program 1 or Program 2 .
5. On the Mode line, select On .
6. On the Type line, select the Burst test pattern.
7. On the Raster Box line, select On .
8. At the projector itself, perform the following adjustments to ensure that the output
data from the selected device is properly displayed:
~
Adjust the image for the minimum amount of noise.
~
Adjust the pixel clock for proper image position, such that the entire
Raster Box is visible.
9. On the Type line, select one of the many Gray Scale test patterns, as desired.
10. At the projector itself, adjust color balance, brightness and contrast.
15
Note This procedure also applies to a single screen “stack”
destination.
Important Refer to your projector’s technical manual for information on
all projector setup and adjustment procedures.