Encore Presentation System • User’s Guide
295
7. Operations
Working with Destinations
iáîÉ=pïáíÅÜ=^ìñ=oçìíáåÖ
Use the following steps to switch Aux destinations live.
1.
On the
Destination Bus
, enable the desired
Aux
destination(s).
2.
Press
Shift + Source
(in the
Live Switch Section
). The
Source
button lights to
indicate the live mode is enabled, and the
Source Selection Bus
is now a “live”
Aux switcher.
3.
On the
Source Selection Bus
, select the desired source. Encore immediately
routes that source to the selected Aux destination(s).
4.
To clear the mode, press
Shift + Source
. The light turns off, and the
Source
Selection Bus
is returned to its normal functionality.
mêçÖê~ãLmêÉîáÉï=^ìñ=oçìíáåÖ
Use the following steps to switch Aux destinations using the Program/Preview method.
1.
On the
Destination Bus
, enable the desired
Aux
destination(s).
2.
Press
Shift + Program/Preview
(in the
Live Switch Section
). The
Program/
Preview
button lights to indicate the mode is enabled.
~
On the
Source Selection Bus
, the bottom row is now the Preview bus,
while the top row is now the Program Bus.
~
The top
Program
bus is now mapped with the same inputs as the bottom
Preview
bus, but note that on both Controllers, only
half
of your inputs
are available:
•
On the
Controller SC
, inputs 1 - 6 and shifted inputs 7 - 12 are
available (but they are mapped to the Preview row). Inputs 13 -
24 are not available.
•
On the
Controller LC
, inputs 1 - 16 and shifted inputs 17 - 32
are available (but they are mapped to the Preview row). Inputs
33 - 64 are not available.
3.
On the Preview Bus, select (pend) the desired source.
4.
Perform the desired transition (e.g.,
CUT
,
AUTO TRANS
). The Program Bus
switches to the new source, and the Preview Bus clears.
5.
To clear the mode, press
Shift + Program/Preview
. The light turns off, and the
Source Selection Bus
is returned to its normal functionality.
Please note the following points regarding the Program/Preview mode:
•
You can not see the selected Preview source prior to transition, because Aux
destinations are "single scaler" devices.
•
Program LEDs are disabled on the
Source Selection Bus
only — not in the
Layer Control Section
.
•
You can also "live switch" directly on the Program Bus.
Source
Note
In this mode, Program LEDs are disabled.
Program
Preview
Содержание Encore
