Barco Encore, Руководство пользователя

Страница: 294 / 404

294 Encore Presentation System • User’s Guide
7. Operations
Working with Destinations
oçìíáåÖ=pçìêÅÉë=íç=^ìñ=aÉëíáå~íáçåë
When using Aux destinations, remember that you are routing individual router inputs to
router outputs, which in turn are connect to other devices. You are not routing the output of
the Video Processors.
•
With Aux destinations (monitors), source selections on the Controller connect a
router input to a selected router output. This output in turn is connected to a
monitor. This is a single-format route.
•
With ImagePRO Aux destinations, source selections on the Controller connect a
router input to a selected router output. This output in turn is connected to one of
three ImagePRO inputs. This is a multi-format route.
•
With PresentationPRO-II Aux destinations, source selections on the Controller
connect a router input to a selected router output. This output in turn is connected
to one of eight PresentationPRO-II inputs. This is a multi-format route.
Several different Aux routing methods are available:
•
Pending and Completing an Aux Route
•
Live Switch Aux Routing
•
Program/Preview Aux Routing
•
Viewing Aux Routes
mÉåÇáåÖ=~åÇ=`çãéäÉíáåÖ=~å=^ìñ=oçìíÉ
„
Use the following steps to pend and complete an Aux destination:
1. On the Destination Bus , enable the desired Aux destination(s).
2. On the Source Selection Bus , select the source that you want to route to the Aux
destination(s).
3. Perform the desired transition in the normal manner (e.g., CUT , AUTO TRANS ).
Once performed, the Aux route is completed.
Note The quality of the selected transition depends on the target
Aux device. For example, with an ImagePRO Aux, you may
get a glitch or a smooth transition, depending on the selected
input patching. With a PresentationPRO-II Aux, you will
always get a smooth transition.
Note At this point, the Aux route is pending. You are free change
sources, or to pend other routes to different destinations (e.g.,
PIP and Key), but the pending Aux route will not be
completed until the next transition is performed.
Note If you want to clear the pending Aux route prior to performing
it, simply clear the lit Aux destination(s).