ASP sterrad NX, Руководство по обслуживанию и устранению неисправностей, Страница: 43 / 126

Diagnostic Tests and Error Messages
4
If you see this message . . . Perform this action.
CANNOT LIGHT PLASMA Inspect the load. If the load is touching the
electrode, reposition the load and start a new
cycle. If the problem persists, run diagnostics. If
diagnostics fail, troubleshoot or replace the
LFPS II power supply
CASSETTE DID NOT INDEX or
CASSETTE SYSTEM TIMEOUT ON
INDEXING or,
CASSETTE SYSTEM TIMEOUT WHEN
PIERCING The system could not communicate with
delivery subsystem while attempting to index the
cassette. Run diagnostics. If diagnostics fail,
adjust or replace the delivery subsystem.
CASSETTE EXPIRED, DISPOSING
CASSETTE or,
CASSETTE EXPIRY FOUND DURING
START CYCLE or,
CASSETTE OUT OF DATE,
DISPOSING CASSETTE or,
CASSETTE USED, DISPOSING Load a new cassette. If message persists, run
diagnostics. If diagnostics fail, adjust or replace
the delivery subsystem.
CHAMBER X TEMPERATURE
DRIFTED HIGHER or,
CHAMBER X TEMPERATURE
DRIFTED LOW or,
CHAMBER X TEMPERATURE HAS
NOT RISEN or,
CHAMBER X TEMPERATURE TOO
HIGH or
CHAMBER X TEMPERATURE TOO
LOW Run diagnostics to determine if a sensor or
heater has failed. Troubleshoot or replace
chamber temperature sensor 1 or 2 (chapter 1 or
2 temp has not risen or temp too high) or the
failed components.
COLLECTION BOX FULL, PLEASE
CHANGE BOX Empty the collection drawer or insert collection
box. If problem persists, troubleshoot or replace
the barcode sensor.
CONDENSER TEMPERATURE HAS
NOT RISEN or,
CONDENSER TEMPERATURE TOO
HIGH or,
CONDENSER TEMPERATURE TOO
LOW
Run diagnostics to determine if a condenser
heater or sensor has failed. Adjust or replace the
vaporizer/condenser assembly.
DELIVERY SYSTEM NOT READY Run diagnostics. Replace the failed component.
STERRAD
®
NX
™
Service Guide 43