182
www.analogway.com
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
USER MANUAL
To choose the mono/stereo mode of a channel pair:
Front Panel
1.
Enter the
AUDIO
menu on the Front Panel interface.
2.
Select
Input Settings
and select an input to set up the audio input.
3.
Select a
Settings Mode
to set up the audio:
•
Select
BASIC
to link channel pairs and use the first channel pair settings for all pairs;
•
Select
ADVANCED
to unlink channel pairs and set up channel pairs individually.
NOTE:
On the
Line In
input, there is only one single channel pair and the
Settings Mode
option is not available.
4.
Select a channel pair if required to set up the channel pair.
NOTE:
•
In
BASIC
settings mode, only the first channel pair settings are available and there is no need to select a channel pair.
•
In
ADVANCED
settings mode, you can select a channel pair to access the channel pair settings.
•
On the
Line In
input, there is only one single channel pair and there is no need to select a channel pair either to access
the channel pair settings.
5.
Check the
Stereo
check-box to force the stereo mode of the audio pair (uncheck to force the
Mono
mode).
Remember:
If channel pairs are linked, the first channel pair setting will be used for all pairs.
TIP:
Toggle the
Listen on the Headphone
box if required to prelisten to the audio pair on the headphone output.
Web RCS
1.
Go to the
Setup
menu on the Web RCS interface.
2.
Click on the
AUDIO
tab to access the audio management page.
3.
In the left side toolbar, select
General
to access the audio inputs and outputs setup page.
NOTE:
You can also access the audio outputs setup page via the
A/V Mapping tab.
4.
Under
Audio Inputs
(right side window), locate the input to adjust and click on the
Ch 1-2/Ch linked
button if required to link/unlink channel pairs:
•
Click on the
Ch 1-2
button to link channel pairs and use the first channel pair settings for all pairs;
•
Click on the
Ch linked
button to unlink channel pairs and set up channel pairs individually.
NOTE:
On the
Line In
input, there is only one single channel pair and the link option is not available.
5.
Select a channel pair if required to set up the channel pair.
NOTE:
•
When channel pairs are
linked
, only the first channel pair settings are available and there is no need to select a channel
pair.
•
When channel pairs are
not linked
, you can select a channel pair to access the channel pair settings.
•
On the
Line In
input, there is only one single channel pair and there is no need to select a channel pair either to access
the channel pair settings.
