136
www.analogway.com
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
PROGRAMMER’S GUIDE
USER MANUAL
5.
Under
BLANKING ADJUSTEMENTS
, adjust the following parameters:
•
H Position:
Adjust the input signal horizontal position.
•
H Size:
Adjust the input signal horizontal size.
•
V Position:
Adjust the input signal vertical position.
•
V Size:
Adjust the input signal vertical size.
Related topics:
•
Overscan compensation
•
Aspect ratio and size
By default, the deinterlacing process used for interlaced input signals does not add any extra frame delay.
You can however disable low latency to improve the image quality, and enable or disable 2:2 and 3:2 pull-
down to optimize the progressive image reconstruction process.
To adjust the deinterlacer options:
Front Panel
1.
Enter the
INPUTS
menu on the Front Panel interface.
2.
Scroll down and select an input to access the selected input setup menu.
TIP:
Double-click on an
INPUT SELECTION
button to shortcut to the input setup menu directly.
3.
Select
Image Settings
to access the input image settings menu.
4.
Select
Deinterlacer
to access the deinterlacer options.
5.
Uncheck
Low Latency
to disable low latency.
NOTE:
Disabling low latency will add an extra frame latency.
6.
If required, uncheck the
2:2 Pulldown/3:2 Pulldown
check-boxes to optimize the progressive image
reconstruction process:
•
Uncheck
2:2 Pulldown
to disable the detection of 2:2 sequences for 50Hz interlaced formats.
7.5.3.7
Adjusting the deinterlacer options (interfaced sources)
