Zeiss OPMI Lumera i, Instructions For Use Manual

Page: 135 / 184

Version 8.0
G-30-1720-en
Page 135
OPMI Lumera i What to do in the event of malfunctions
Malfunctions of the FCP foot control panel
Error messages on the 5.7" control panel
In the event of malfunctions occurring during operation, an error message is
displayed on the 5.7" control panel.
• Check and eliminate the malfunction.
• Acknowledge the error message.
The following table contains examples of error messages and the corresponding
remedies. If you have problems eliminating the malfunction or if errors keep
recurring, do not continue using the system and contact ZEISS Service.
You will find the contact responsible for your country on the following website:
www.meditec.zeiss.com
Fault Possible reason Corrective measure Cross
reference
Foot control panel is
inoperative. Connections on suspension
system or foot control panel
not plugged in. Plug in connectors. Page 77
Error message Possible reason Corrective measure Cross
reference
XY coupling error. The error
can be acknowledged.
If the error impairs your work,
switch to the manual mode
and contact ZEISS Service.
– e.g., hardware error in
motor electronics
– e.g., software error,
inadmissible status of
motor control
If the error impairs your work,
switch to the manual mode. Page 131
Light source error. The error
can be acknowledged.
If the error impairs your work,
switch to the manual mode
and contact ZEISS Service.
– e.g., malfunction of light
intensity setting If the error impairs your work,
switch to the manual mode. Page 131