Zeiss OPMI Lumera i, Instructions For Use Manual

Page: 10 / 184

Safety measures OPMI Lumera i
Version 8.0
Page 10 G-30-1720-en
• Never look at the sun through the binocular tube, the objective lens, or an
eyepiece.
• The maximum brightness of the lamp(s) can drop over time (normal device
attribute).
Ambient conditions • Do not use the power-operated devices included in the delivery package
– in areas where there is a risk of explosion,
– or at a distance of less than 25 cm from flammable anesthetics or
volatile solvents such as alcohol, benzine, or similar substances.
• Do not use or store the device in a damp place. Do not expose the device
to dripping water, running water, sprayed water, or splashes.
• Ensure that fluids cannot enter the device.
Electrical safety • Always switch off the device before you plug it into or unplug it from
a power socket, if you are not going to use it for a prolonged period of
time, or if you want to clean its surface.
• Switch off the system at the power switch if you notice any smoke, sparks,
or unusual noise. Do not use the unit until it has been repaired by the ZEISS
Service team.
A potential equalization connector is provided on the instrument’s connection
panel (see IEC 60601-1). This connector can be used to connect other active
devices to the same ground potential or for redundant connection to the
protective ground.
• Do not use multiple sockets!
• Do not remove any parts of the housing! The system contains components
that carry high voltage and may cause electric shock.
• Do not touch the device if your body is electrostatically charged and the
device is not grounded.
• Before connecting the system to line power, make sure that the power
network is free from defects that may lead to dangerous voltage on the
power plug.
• Do not pull on the light guide, power cord, or any other connecting
cables.
• Please note the information on EMC (electromagnetic compatibility) in the
chapter "System data" on Page 158.