Zeiss OPMI Lumera i, Instructions For Use Manual

Page: 140 / 184

Care and maintenance OPMI Lumera i
Version 8.0
Page 140 G-30-1720-en
Changing the halogen lamp
The following steps are required for changing the lamp:
• Turn off the device at the power switch.
• Press button (2) to eject lamp module (1) partially. Pull out the lamp module.
• Remove the defective halogen lamp from the spring-loaded mount.
• Pull the ceramic base (8) from the contact pins of the halogen lamp.
• Plug the ceramic base (8) onto the contact pins of the new halogen lamp.
• Insert new halogen lamp. Make sure you do not touch the lamp bulb (7)
or the interior of the reflector (6).
• Press the halogen lamp into the spring-loaded mount (4)/(5).
• Push the lamp module including the new halogen lamp back into the
device.
• Turn on the device at the power switch.
3 “Instructions for Use” sign
Observe the Instructions for Use or further applicable documents.
9 “CAUTION” warning label
Warning of a potential hazard.
•
Follow the instructions to change the lamp.
NOTE 10 Risk of burns caused by hot lamp!
If you replace the lamp shortly after it has failed, the lamp will still be very hot.
• Allow the lamp to cool down before removing it.
• Always use heat-resistant protective gloves when replacing the lamp!
NOTE Use the correct halogen lamp
• Only use the 12 V, 100 W halogen lamp specified in “Ordering data,
Consumables”.