NOTES ON DEVICE SAFETY
Warning and information labels
LSM 510
1-8
B 40-051 e 07/98
1.7
Warning and information labels
The warning and information labels attached on the LSM 510 must be observed. Check
whether all of the labels shown below are provided on your instrument, and contact Carl Zeiss
Germany or one of the service agencies if you should discover that any of the labels should be
missing. You will receive a free replacement.
The
label means: "Do not remove securing screw as otherwise laser beam will escape. For
use by service only!"
Fig. 1-1
Warning and information labels on the Axiovert 100 M microscope with the LSM 510
scanning module
Avoid exposure to beam
when cover is removed.
WARNING: LASER RADIATION
11
0
120
130
140
150
160
170
50
60
70
80
90
100
HAL
100
12V max. 100W
447219
12V 100W
LSM 510
See instruction manual.
Laser radiation when parts removed.
DANGER
Avoid direct exposure to beam.
LASER RADIATION
Avoid exposure to beam
Laser class 3D (IEC 825)
LASER
Exit aperture
Summary of Contents for LSM 510 Inverted
