Now the project engineering of the PROFINET IO controller is finished. Please link up
now your IO devices with periphery to your IO controller.
1.
For the project engineering of the PROFINET IO device you search the concerning
PROFINET IO device in the hardware catalog at
PROFINET-IO
and drag&drop it in
the subnet of your IO controller.
2.
Assign a name to the IO device. The configured name must match the name of the
device. Information about setting the device name can be found in the manual of
the IO device.
3.
Enter a valid IP address. The IP address is normally assigned automatically by the
hardware configurator. If this is not desired, you can assign the IP address man-
ually.
4.
Link up the modules of your IO device in the plugged sequence and add the
addresses that should be used by the modules.
5.
If needed, parametrize the modules.
6.
Save, compile and transfer your project.
Chap. 13.10 ‘TIA Portal - Project
Device overview
Module
...
Slot
...
Type
...
...IO device..
...
0
...
...IO device..
...
...
...
0
...
...
...
Module
...
1
...
Periphery modules
...
...
...
2
...
...
...
...
...
...
...
...
...
13.6.2
Deployment as PROFINET I-Device
13.6.2.1
Steps of configuration
Please regard that the PROFINET I-Device supports only the PROFINET
functions, which are described in this manual, even if the Siemens CPU,
which is used for configuration, offers further functionalities!
Configure IO devices
Functionality
VIPA System SLIO
Configuration with TIA Portal
TIA Portal - Deployment PG/OP communication - PROFINET > Deployment as PROFINET I-Device
HB300 | CPU | 013-CCF0R00 | en | 19-30
310