Yamaha YZ250(P)/LC, Owner'S Service Manual

Page: 58 / 584

1-15
STARTING AND BREAK-IN
GEN
INFO
c C
9
After the break-in or before each race, you
must check the entire machine for loose fit-
tings and fasteners as per “TORQUE-
CHECK POINTS”.
Tighten all such fasteners as required.
9
When any of the following parts have been
replaced, they must be broken in.
CYLINDER AND CRANKSHAFT:
About one hour of break-in operation is
necessary.
PISTON, RING AND GEARS:
These parts require about 30 minutes of
break-in operation at half-throttle or less.
Observe the condition of the engine careful-
ly during operation.
5NX-9-30-1 6/5/01 3:53 PM Page 34