Yamaha YZ250(P)/LC, Owner'S Service Manual

Page: 116 / 584

2-13
CABLE ROUTING DIAGRAM
SPEC
EC240000
CABLE ROUTING DIAGRAM
1
Fuel tank breather hose
2
Cable guide
3
Throttle cable
4
Clamp
5
Clutch cable
6
Wireharness
7
“ENGINE STOP” button lead
8
CDI unit
9
CDI unit stay
0
CDI unit band
q
TPS (throttle position sensor)
lead
w
Solenoid valve lead
e
Air vent hose (left)
r
Transmission oil breather hose
t
Overflow hose
y
Air vent hose (right)
A
Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
B
Pass the throttle cable and
“ENGINE STOP” button lead into
the cable guide. Align with the
cable guide the front end of the
tape on the throttle cable.
C
Pass the throttle cable and
“ENGINE STOP” button lead
over the radiator hose.
D
Clamp the throttle cable and
“ENGINE STOP” button lead with
the clamp ends downward.
E
Pass the clutch cable a little for-
ward of the extreme left nut that
holds the cylinder head.
F
Pass the wireharness between
the engine brackets.
G
Pass the air vent hoses, overflow
hose and transmission oil
breather hose between the frame
and connecting rod.
H
Fit the CDI unit band into the CDI
unit stay till it stops.
I
Insert the CDI unit into the CDI
unit band till it stops.
J
Clamp the TPS (throttle position
sensor) lead and solenoid valve
lead at the side of the TPS with
the clamp ends backward.
K
Clamp the air vent hoses.
L
Pass the air vent hoses, overflow
hose and transmission oil
breather hose so that all these
hoses do not contact the rear
shock absorber.
5NX-9-30-2 6/7/01 1:57 PM Page 50