Yamaha MM700A, Manual, Page: 204 / 282

198 CHAPTER TEN
Reassembly
to Figure
removed, install the flanged (Figure 44) and
shims into the sliding sheave half.
2. Install the stopper (Figure onto the fixed sheave
half.
3. If the bushings removed, install them into the
sliding sheave and spring
4. Install the sliding sheave half' into the fixed sheave
half.
Install the spring and spring as follows:
a. Note the on the fixed sheave half
(Figure
and the spring
(Figure 49).
b. Refer to Table 17 and install the spring into the
fixed sheave inserting the spring end into the
numbered hole specified.
to Table install spring
onto the spring so the spring end resides in the num-
bered specified.
While holding the spring rotate the fixed
sheave half at the specified angle listed in Table
The studs on the sliding sheave half should align
with the bolt holes in the
Push the spring
(A, Figure 41) down onto
the studs install the retaining nuts (B). Tighten
the nuts to
23 (204
Install the secondary sheave as described in this chap-
ter. Also perform the
Drive Belt
and
Drive Belt
Height procedures described in this chapter.