Yamaha MM700A, Manual, Page: 134 / 282

128 CHAPTER FIVE
CARBURETOR OPERATION
OPENING
TO FULL)
Air
5.
Disconnect the connector leads to the throttle override
switch (Figure 10).
6. Loosen the jam nut (Figure
on the starter
then and disconnect the starter cable.
7. Disconnect the throttle cable
(Figure
8.
then disconnect the hoses from the carburetor.
Plug the hoses to prevent fuel and contamination.
carburetor assembly is removed
fur
9. Place a suitable container under each carburetor, then
remove the fuel drain screw
(Figure and drain the fuel
from each carburetor.
Loosen the hose clamps around the intake tubes that
secure the carburetors to the intake tubes.
Be prepared to catch residual
that may
Remove the carburetor assembly
(Figure 13).
12. Reverse the removal steps to the carburetor as-
sembly while noting the following.
a. Adjust the as described in Chapter
Three.
b. Adjust the starter cable as described in Chapter
Three.
Refill coolant and bleed the cooling system as
described in Chapter Three.
sure the fuel hoses are properly connected to
prevent a fuel leak.
not start the are
leaking.
e. Make the intake tubes are properly positioned
and the hose clamps are tightened securely to pre-
vent an air leak.
Carburetor Assembly
to Figure 14.
1. Remove the carburetor assembly from the engine as
previously described.
Be prepared to catch arty coolant
from the
2. Remove the heater hoses (Figure between the
buretors.