Xerox WorkCentre C226, System Administration Manual, Page: 84 / 216

2-34 Xerox WorkCentre C226 System Administration Guide
Key Operator Programs
Auto colour calibration
The Auto Colour Calibration program enables automatic colour gradation correction
when the colour reproduction is incorrect.
NOTE: The colour gradation may not be sufficiently corrected after one correction cycle. If so,
execute the program again.
When the [AUTO COLOUR CALIBRATION] key is touched, the following display will
appear.
After the [EXECUTE] key is touched and a test patch printed, a message appears ask-
ing you to begin automatic adjustment. Place the test patch on the document glass as
shown below and touch the [EXECUTE] key.
NOTE: Lay approximately five sheets of copy paper that are the same size as the test patch
on top of the set test patch, and gently close the document cover.
When a message appears informing you that auto colour calibration is completed,
touch the [OK] key to end the procedure.
NOTE: Before executing this program, check to see if the registration adjustment is correct. If
not, execute [AUTO ADJUSTMENT] in [Registration adjustment] on page 12.
Key Operator Programs
OK
Auto Colour Calibration
Use 11"X17" Or A3 Paper For This Adjustment.
Press [Execute] To Print The Test Patch.
Execute
Cyan
Magenta
Yellow
Black