Xerox WorkCentre C226, System Administration Manual, Page: 81 / 216

Programs for Copy Mode
Xerox WorkCentre C226 System Administration Guide 2-31
Programs for Copy Mode
This chapter explains the key operator programs that are used for copy mode.
Copy settings
Other Function Settings
"Other function settings" consists of the following programs:
• Initial status settings
• Exposure adjustment
• Rotation copy setting
• Add or change extra preset ratios
• Initial margin shift setting
• Erase width adjustment
• Setting a maximum number of copies
• Initial colour balance setting
• Auto colour calibration
• B/W 600dpi scanning mode for DADF
Initial status settings
The copier settings will be reset when the main switch is turned off, when the [CA] key
is pressed, or when the auto clear interval has elapsed. Use this program to establish
new initial settings or to return the initial settings to the factory default settings. Paper
tray, exposure mode, copy ratio, duplex mode, and output mode default settings can
be selected.
NOTE: Even if the default state of the two-sided function has been set to other than one-sided
to one-sided copy mode using this program, in the event that the two-sided function of
the optional duplex module/2-tray unit or the DADF has failed or has been prohibited*
from use, the default state will revert to one-sided to one-sided copy mode.
* Disabling of DADF (page 2-23)
Disabling of duplex (page 2-24)
Disabling of inverter (page 2-24)
Disabling of optional paper drawer (page 2-24)