Xerox WorkCentre C226, System Administration Manual, Page: 79 / 216

General Programs
Xerox WorkCentre C226 System Administration Guide 2-29
Return from copy mode timing
After printing ends in copy mode, this program is used to set the amount of time until
the mode is changed and printing begins of a job waiting in printer mode or fax mode.
The amount of time can be set from 0 second to 60 seconds in increments of 1 sec-
ond.
List print
This program is used to print lists of key operator programs.
Lists of key operator programs for copier, fax, printer and network scanner features
are available.
Key operator code change
This program is used to change the key operator code.
The key operator must register a key operator code number and use the number to
gain access to key operator programs. Only one key operator code number can be
registered. The factory has registered "00000" as the code number to allow initial
access to the programs. It is recommended that the key operator use the factory num-
ber for initial entry into the programs and then choose and enter another number by
this program.