Xerox WorkCentre C226, System Administration Manual, Page: 83 / 216

Programs for Copy Mode
Xerox WorkCentre C226 System Administration Guide 2-33
Erase width adjustment
Set the initial setting of the amount of the erase area with this program.
The values can be set from 0 mm to 20 mm in 1 mm increments or from 0" to 1" in 1/8"
increments.
Setting a maximum number of copies
Use this program to limit the maximum number of copies per copy run which can be
input in the copy quantity display.
A number from 1 to 999 can be set.
Initial colour balance setting
Colour balance settings that have been adjusted using the special "Colour Balance"
function can be called up and set as initial colour balance settings* by storing them
ahead of time in a job program. Use this feature when you want to repeatedly use set-
tings for a favorite colour or for correction when a change occurs in the colour balance.
* Preset values displayed when you select the special "Colour Balance" function. The
factory default settings are the "0" position for all eight levels of each colour.
When the [INITIAL COLOUR BALANCE SETTING] key is touched, the following dis-
play will appear.
If a job program number key is touched that does not have colour balance settings, a
warning message will appear.
To return colour balance settings that have been stored as initial settings to the factory
default settings (the "0" position for all eight levels of each colour), touch the [RETURN
TO THE FACTORY DEFAULT SETTINGS.] key.
Key Operator Programs
OK
Initial Colour Balance Setting
Press Program Number In Which Colour Balance Program Is Registered.
1
6
2
7
3
8
4
9
5
10
Return To The Factory Default
Settings.