Xerox WorkCentre C226, System Administration Manual, Page: 197 / 216

Key Operator Programs
Xerox WorkCentre C226 System Administration Guide 6-51
Initial resolution setting
This setting is used to change the default resolution setting for fax mode from "STAN-
DARD" to "FINE", "SUPER FINE", or "ULTRA FINE". "HALF TONE" can also be
selected for the latter three resolution settings. "STANDARD" is normally selected for
the initial resolution setting. If you wish to select "HALF TONE" for the selected resolu-
tion setting, touch the [HALF TONE] key to highlight it.
NOTES: • "HALF TONE" cannot be selected for "STANDARD" resolution.
• For more information on each of the resolution settings, refer to your Xerox
WorkCentre C226 User Guide.
Own number and name set
Use this setting to enter the fax number of the machine and the name of the user. The
entered name and number are printed at the top of each fax page you send. The num-
ber is also used as a passcode when performing polling reception.
You can check your entries by printing out the Sender List. Refer to page 6-63.
1. Touch the [NAME] key and enter the name.
The name entry screen appears.
Up to 20 characters can be entered for the name.
Refer to your Xerox WorkCentre C226 User Guide for the procedure for entering
characters.
2. Touch the [FAX No.] key and enter the fax number.
Enter up to 20 digits for the number using the numeric keys.
To enter a "+", press the " " key.
To enter a hyphen, touch the [PAUSE] key. To enter a space, touch the [SPACE]
key.
If you make a mistake, press the [C] key and re-enter the correct digit.
NOTE: If a hyphen is entered, it will be changed to a space at the time of transmission.
3. Touch the [OK] key.
You will return to the OWN NUMBER AND NAME SET screen. The number you
entered appears. Make sure it is correct.