Wilo Yonos GIGA2.0-D, Installation And Operating Instructions Manual

Page: 191 / 424

Reset en
Installation and operating instructions Wilo-Yonos GIGA2.0-I/-D 191
16.1 Factory setting
NOTICE
Resetting pump settings to factory settings replaces the current pump settings!
Reset to
factory setting
Confirm
(settings will be lost)
Cancel
Fig. 98: Confirm reset to factory setting
The table gives an overview of the factory settings:
Settings Yonos GIGA2.0 Yonos GIGA2.0 ... R1
Set control mode
Settings assistant Δp-v Basic control mode
n-const.
Pump On/Off Motor on Motor on
Twin-head pump operation
Connecting twin-head pump Single pump: not connected
Twin-head pump: connected
Single pump: not con-
nected
Twin-head pump: con-
nected
Twin-head pump alteration 24 h 24 h
External interfaces
SSM/SBM relay
Relay function SSM SSM
SSM relay function Only errors Only errors
Trigger delay 5s 5s
Reset delay 5s 5s
DI1 active (with cable bridge) active (with cable
bridge)
AI1 configured
Type of use: differential
pressure sensor
Sensor position: pump flange
Signal type: 2 ... 10 V not configured
AI2
not configured not configured
Wilo Net
Wilo Net termination switched on switched on
Wilo Net address Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
Display setting
Language English English
Units m, m
3
/h m, m
3
/h
Pump kick switched on switched on
Pump kick time interval 24 h 24 h
Diagnostics and measured
values
Diagnostics help
SSM forced control (normal,
active, inactive) inactive inactive
SBM forced control (normal,
active, inactive) inactive inactive
Additional settings
Pump kick switched on switched on