Wilo Yonos GIGA2.0-D, Installation And Operating Instructions Manual

Page: 152 / 424

en Commissioning
152 WILO SE 2022-05
Universal Display text
Setpoint = Setpoint =
1.1.3 Kp
2
Parameter Kp
2
1.1.4 Ti
2
Parameter Ti
2
1.1.5 Td
2
Parameter Td
2
1.1.6
2
Control inversion
2
OFF Inversion OFF
ON Inversion ON
1.1.7 Emergency operation
OFF Pump OFF
ON Pump ON
1.1.8
3
Emergency operation speed
3
1.1.9 Setpoint source
1.1.9 / 1 Internal setpoint
1.1.9 / 2 Analogue input (AI2)
1.1.9 / 3 CIF module
1.1.10
4
Substitute setpoint
4
1.1.15 Pump ON/OFF
OFF Switched off
ON Switched on
1.3 External interfaces
1.4 Dual pump management
1.5 Display settings
1.6 Additional settings
1
According to the currently set control mode, only the corresponding setpoint opens.
2
The menu item only opens if the PID control mode is set.
3
The menu item only opens if emergency operation is set to “ON”.
4
The menu item only opens if analogue input AI2 is selected as the setpoint source.
9.4.8 Main menu “Settings”
Different settings can be changed in the “Settings” menu .
Settings
Control settings
External interfaces
Dual pump management
Fig. 35: Settings menu
The “Settings” menu is selected by turning the operating button to the “gear wheel”
symbol .
Confirm the selection by pressing the operating button. Selectable submenus open.
Select a submenu by turning the operating button to the right or left. The selected sub-
menu item is highlighted in colour.
Press the operating button to confirm the selection. The selected submenu or down-
stream settings dialogue appears.
NOTICE
If there are more than three submenu items, this is indicated by an arrow
1
above
or below the visible menu items. Turn the operating button in the corresponding dir-
ection to open the submenu items on the display.