CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
95
Range
[Factory Setting]
Parameter
Unit
Description / Notes
P204
Action
0, 1, 2,
Not used:
4, 6, 9
No action
3
Reset P043:
Resets Running Time
5
Loads Factory Default:
Loads current Soft-Starter parameter
with factory setting
7
Loads User 1:
Loads current Soft-Starter parameter
with the values stored in
Memory 1.
8
Loads User 2:
Loads current Soft-Starter parameter
with the values stored in
Memory 2.
10
Save User 1:
Transfer the current parameter
contents of the Soft-Starter to memory 1
11
Save User 2:
Transfer the current parameter
contents of the Soft-Starter to memory 2
NOTE!
Parameter loading/saving will be executed only after parameter
setting and after the key
has been pressed .
This Parameter selects which parameter listed below will be displayed
after the Soft-Starter has been powered-up:
P205
0 to 7
Display Default
[ 2 ]
Selection
-
In the event of a fault trip, except for E10, E15, E24, E28, E29,
E30, E31, E41, E62, E63, E67, E70, E71, E72, E75, E76 and E77,
the Soft-Starter SSW-06 can initiate an automatic reset after the
time given by P206 is elapsed.
If P206
2 Auto-Reset does not occur.
If after Auto-Reset the same fault is repeated three times consecutively,
the Auto-Reset function will be disabled. A fault is considered
consecutive if it happens again within 30 seconds after Auto-Reset.
Thus if an error occurs four times consecutively, it will be displayed
permanently (and the Soft-Starter will be disabled).
P206
0 to 600
Auto-Reset Time
[ 0=Inactive ]
1s
Table 6.17
- Action of loading/saving parameters
P205
Status
1
P001 (Motor current % In of the Soft-Starter)
2
P002 (Motor current % In of the Motor)
3
P003 (Motor current (A))
4
P004 (Supply Line Voltage)
5
P005 (Supply Line Frequency)
6
P006 (Soft-Starter Status)
7
P007 (Output Voltage)
Table 6.18
- Options displays default
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
