CHAPTER 3 - INSTALLATION AND CONNECTION
48
An optional Profibus DP or DeviceNet Communication board can be
attached to this connector.
For more details see the Profibus DP or DeviceNet Communication
Manual of the Soft-Starter SSW-06 and chapter 9.
3.2.11 XC6 Fieldbus
Communication Board
Connection
Figure 3.21
– X2, XC6 and XC8 Connector
3.3
RECOMMENDED
SET-UPS
In this item some suggestive starters are presented, which can be
used completely or in part to elaborate the desired control.
The main warnings, for all the suggestive starters, listed below, are
related in the diagrams through their respective numbers.
NOTES!
For the protection of all of the electrical installation, the use of
fuses or circuit breakers in the main power supply circuit is
necessary.
The use of high speed semiconductor fuses are not necessary
for the functioning of the SSW-06 Soft-Starter, but its use is
recommended for the complete protection of the thyristors.
The transformer “T1” is optional and should be used when the
line voltage is different from the electronics and fan voltage;
To protect the motor against destruction by possible short-
circuits in the power circuit of the Soft-Starter SSW-06 use an
isolating contactor (K1) or circuit-breaker (Q1);
3.2.9
RS-232, X2 Serial
Communication Connection
3.2.10 RS-485, XC8 Isolated Serial
Communication Board
Connection
This connector is used to make a standard RS232 communication line
between the Soft-Starter SSW-06 and a PC and/or PLC.
For more details see the Serial Communication Manual of the
Soft-Starter SSW-06.
An optional board of serial communication, standard RS-485 with
galvanic insulation, can be attached to this connector.
For more details see the Serial Communication Manual of the
Soft-Starter SSW-06.
1
2
3
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
