CHAPTER 4 - KEYPAD (HMI) OPERATION
63
7 Segment Display is flashing:
The display flashes in the following conditions:
trying to change a parameter value when it is not allowed;
Soft-Starter in Fault condition (Refer to Chapter 7 - Diagnosis and
Troubleshooting)
All Soft-Starter settings are made through the parameters. The
parameters are shown on the display with the letter
P
followed by a
number:
Example (P101):
4.2.3 Parameter viewing and
programming
Init. Volt Start
P101=30%
101= Parameter Number
Each parameter is associated to a numerical value (parameter content),
that corresponds to an option selected among the options available for
this parameters.
The values of the parameters define the Soft-Starter programming or
the value of a variable (and.g. current, frequency, voltage). For Soft-
Starter programming you should change the parameter(s) content(s).
Press the key
Use the keys
and
ACTION
DISPLAY HMI LED
DESCRIPTION
DISPLAY HMI LCD
SoftStarter
Ready
Motor Current
P000=0.0%
Init. Volt Start
P101=30%
Select the desired parameter
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
