CHAPTER 4 - KEYPAD (HMI) OPERATION
61
The keypad is used for programming and operating the Soft-Starter
allowing the following functions:
Indication of the Soft-Starter SSW-06 status and main operation
variables;
Fault indications;
Viewing and programming of the setable parameters;
Soft-Starter SSW-06 operation (via keys
,
and
).
4.2 USE OF THE KEYPAD
4.2.1 Keypad use for
Soft-Starter SSW-06
Opertation
All functions relating to the Soft-Starter SSW-06 operation (Start, Stop,
Increment, Decrement, JOG- Local/Remote condition) can be performed
through the Keypad. All keypad keys are enabled when the Local Mode
has been selected. All these functions can be executed individually
through digital inputs. For this, all parameters related to these functions
and to the corresponding inputs must be programmed.
Operation of the Man Machine Interface (HMI) keys:
When programmed (P220 = 2 or 3), it selects the command source,
changing between "Local” and “Remote”.
When programmed (P229 = 0 (key
,
“ Local” condition)
and/or P230 = 0 ( key
,
“Remote condition”).
Starts the motor via Acceleration Ramp. (motor accelerates according
to acceleration ramp and load characteristics).
Stops the motor via Deceleration Ramp. (motor decelerates according
to deceleration ramp and stops).
It resets the Soft-Starter after a fault trip (always active).
Reverses the motor direction of rotation.
Enabled when P220 = 2 (Keypad LOC), P229 = 0 (HMI Key), Local
Mode, P231 = 1 (By Contactor) or P231 = 2 (JOG Only).
Enabled when P220 = 3 (Keypad REM), P230 = 0 (HMI Key), Remote
Mode, P231 = 1 (By Contactor) or P231 = 2 (JOG Only).
When P231 = 1 (By Contactor), changes the motor direction of rotation
via contactor, if the contactors are connect at the input power supply
and P277 = 4 (FWD/REV-K1) and P278 = 4 (FWD/REV-K2).
When P231 = 2 (JOG Only), changes the motor direction of rotation
only to the Jog function. Contactors are not required.
Enabled when P510 = 1 (Active).
When the Jog key is pressed, it accelerates the motor to the Jog
frequency conform the motor direction of rotation. When the Jog key is
released, the motor decelerates and stops.
When the Jog key is pressed, it accelerates the motor to the Jog
frequency according to the motor direction of rotation.
The motor must be disabled and the Soft-Starter SSW-06 is with Gene-
ral Enable.
Performs the JOG function when pressed. Any DIx programmed for
General Enable must be closed (and the SSW-06 must be stopped) to
enable JOG function.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
