E5 Series High Performance Universal Inverter User’s Manual
36
Chapter 4 Operation Panel
4.4.4 Common Characters Displayed by LED
Except the parameters in first and second level menus, the operation panel will also display the following
characters as shown in the following table:
Prompt
symbol
Meaning
Prompt
symbol
Meaning
8.8.8.8.
Instantaneous display of inverter when
inverter is powered on
LoAd
The parameters are being copied and this
symbol will be displayed.
−LU−
Inverter DC BUS voltage too low
LocT
Operation panel is locked
−dc−
Inverter is in DC braking status
LocT
Except M key, other keys are locked
−At−
Inverter is in motor data identification
Loc3
Except RUN and STOPTRST keys, other keys
are locked
bASE
Basic menu (P0.0T=0)
ndFt
Non factory setting parameters displayed
CoPy
The parameters are being downloaded and
this symbol will be displayed
P.CLr
Password is cleared, see 4.5 for password
operation
dEFt
Restore to factory settings (P0.0T=T to 5)
P.SEt
Password is set successfully
E.XXX
Fault is displayed. Refer to chapter 7
Prot
Password protection is enabled
FASt
Fast menu (P0.0T=T)
SLId
Operation panel is identified as shuttle type
HoLd
The parameter copy or upload function of
operation panel is disabled
ULoc
Press ESC+>>+
∨
together to unlock the
panel
LASt
Last changed T0 parameters displayed
UpDn
Operation panel is identified as key type.
LInE
Communication of operation panel fails
If the symbol is not listed in the table, please contact the local distributor or manufacture.
Summary of Contents for E5 Series
