V&T E5 Series, User Manual

Page: 128 / 157

E5 Series High Performance Universal Inverter User’s Manual
Chapter 6 Parameter Descriptions 115
6.T7 Display Parameters (Group dT)
Parameters in dT group are read only parameters.
dT.06 and dT.07 is used to display the adjustment value of operation panel
∧ T ∨ and terminal UPTDN.
dT.09 is used to display the digital input terminal status, 0 indicates terminal is OFF, while T indicates ON.
Bit 0 to bit6 corresponds to XT to X7.
dT.TT indicates the fault source of analog input. T indicates AIT exceeding limit, T indicates AIT
exceeding limit, 3 indicates AI3 exceeding limit, 4 indicates AV4TAI4 exceeding limit, and 5 indicates
AV5TAI5 exceeding limit. Among them 4 and 5 only valid when use EX−PM0T.
dT.T3 indicates the current detection fault source display. T indicates phase W abnormal, 4 indicates
phase V abnormal, and 6 indicates phase U abnormal.
dT.T4 indicates the frequency corresponds to the actual motor rotation speed under vector control T with
encoder speed feedback.
0 ~ 65535 (factory) Reserved dT.T6~dT.T4
0 ~ 65535 (0)
Reserved
dT.T5
0.00 ~ 655.35Hz (0.00Hz) Frequency corresponding to motor rotation speed dT.T4
0 ~ 6 (factory) Output current detection fault source display dT.T3
0 ~ 5 (factory)
AI fault source display
dT.TT
0.0 ~ T00.0 % (factory) Reference voltage T (percentage) dT.TT
0.0 ~ T00.0 % (factory)
Reference voltage T (percentage)
dT.T0
0 ~ FFFF (0000)
X terminal status dT.09
0 ~ FFFF (factory)
Software compile date dT.08
0 ~ 65535 (0)
Terminal UPTDN digital adjustment value
dT.07
0 ~ 65535 (0) Operation panel ∧/∨ digital adjustment value dT.06
0.0 ~ T00.0 % (0.0%)
DI percentage after transformation
dT.05
0.0 ~ T00.0 % (0.0%) AI3 percentage after curve transformation dT.04
0.0 ~ T00.0 % (0.0%) AIT percentage after curve transformation dT.03
0.0 ~ T00.0 % (0.0%)
AIT percentage after curve transformation
dT.0T
0 ~ 65535 (0) Terminal count value dT.0T
0.0 ~ T00.0 º C (0.0 º C)
Heat-sink T temperature
dT.00