V&T E5 Series, User Manual

Page: 88 / 157

E5 Series High Performance Universal Inverter User’s Manual
Chapter 6 Parameter Descriptions 75
The following table lists the multi−function digital input terminal functions:
Setting
value
Function
Setting
value
Function
00 Jog forward T7 Stop via terminal with DC braking T
0T Jog reverse T8 Counter input
0T Forward (FWD) T9 Counter reset
03 Reverse (REV) 30~3T Reserved
04 Three−wire control 3T Force to wake-up
05 Pulse frequency DI input ( X7TDI) 33~46 Reserved
06 Multi−step digital voltage terminal T 47 Single phase pulse input for closed loop control
07 Multi−step digital voltage terminal T 48 Run command is changed to operation panel
08 Multi−step digital voltage terminal 3 49 Run command is changed to terminal
09 Multi−step frequency terminal T 50 Run command is changed to communication
T0 Multi−step frequency terminal T 5T
Changeover between process close loop control
and open loop control
TT Multi−step frequency terminal 3 5T Main frequency reference is changed to digital
TT Multi−step frequency terminal 4 53 Reserved
T3 AccelerationTdeceleration time terminal T 54 Main frequency reference is changed to AIT
T4 AccelerationTdeceleration time terminal T 55 Main frequency reference is changed to AIT
T5 Clear UPTDN regulation value 56 Main frequency reference is changed to AI3
T6 Terminal UP (frequency increase) 57 Main frequency reference is changed to DI
T7 Terminal DN (frequency decrease) 58 Auxiliary frequency reference is changed to NONE
T8 Acceleration and deceleration is prohibited 59 Reserved
T9 External fault input 60 Auxiliary frequency reference is changed to AIT
T0 Fault reset (RESET) 6T Auxiliary frequency reference is changed to AIT
TT Run pause 6T Auxiliary frequency reference is changed to AI3
TT Run is prohibited 63 Auxiliary frequency reference is changed to DI
T3 Stop via terminal 64~66 Reserved
T4 Coast to stop via terminal 67 Process closed loop output forced to 0
T5 Stop via terminal with DC braking T 68 PID positive logic or negative logic selection
T6 Emergency stop T (fastest stop) 69~98 Reserved
00: Terminal jog forward input
0T: Terminal jog reverse input
0T: Terminal run forward input (FWD)
03: Terminal run reverse input (REV)
The functions of above items 0 to 3 are only enabled when the run command reference channel is
terminal (P0.06=T). Terminal run command and jog run command should be interlocked.
04: Three−wire control
It is only enabled in the terminal run command reference mode (P0.06=T). Refer to parameter P5.TT.
05: Pulse frequency DI input (only available for X7TDI terminal)
When the pulse frequency DI input acts as the reference (e.g. P0.04=4 or PT.0T=4), this function
must be selected for the X7TDI terminal.