Transas T214, Technical Manual

Page: 115 / 115

Troubleshooting
Chapter 9. List of alarms and troubleshooting.
113
№ Fault manifestation Group Probable
cause
Cure
Navigational
data sources
are not
connected. Connect navigational
data sources (see
under “Creating Virtual
Sources of Coastal
AIS Base Station T214
Equipment
Coordinates”).
Incorrect
interface
setup. Set up interfaces in the
setup menu.
If the setup is
correct, the
connection
cable may be
broken. Restore the cable if the
appropriate tools and
materials are available.
10 AIS Base Station T214 equipment
does not have navigational data 3
Serial port
burned off Contact the service
centre.
Incorrect
connection of
the internal
GNSS
antenna. Check and connect
correctly. 11 Output of internal GPS/GLONASS
receiver malfunction diagnostics 3
If the
antenna is
connected
correctly but
the internal
GNSS
receiver does
not start to
operate
correctly
within half an
hour required
for the
almanac
loading Contact the service
centre.
12 Diagnostic message about the VSWR
value exceeding the permissible limits 3 Incorrect
connection of
the VHF
antenna . Check and connect
correctly.
13 Transmitter malfunction message is
displayed 3 Contact the service
centre.
14 Transmitter malfunction message is
displayed 3 Contact the service
centre.