Transas T214, Technical Manual

Page: 64 / 115

Navigational data sources setup
TRANSAS AIS BASE STATION T214. Technical Manual.
62
Select as Source of PPS the PPS-Sen1 value, as Source of NMEA – Sensor 2
value. Select “Enable” to enable second synchronization source.
If virtual sources of all the types are set to the initial condition (by using the “Reset”
button), operation of AIS Base Station T214 in the part of receiving navigational data
is in compliance with IEC-61993-2. The change of standard rules may be required
for adapting the Base Station for the specific features of the particular coastal
equipment.
As you exit from the “Main Setup” menu, press “Yes” when prompted by the device
to confirm changes.
6.7.4
Setup of differential corrections data sources
The definition of virtual sources of differential data requires the setting of serial ports
only.
AIS Base Station T214 can receive differential corrections data from the serial ports
set in the Configuration->Setup->Sensor setup->Sources of diff. data menu.
The “Change” button allows control parameters set for the virtual source to be
changed. The “Reset” button deletes all the user-entered control parameters and
sets standard parameters in compliance with IEC 61993-2 standard.