Configuration Guide
762
Configuring SNMP & RMON
Configuration Example
6.3 Network Topology
As shown in the following figure, the NMS host with IP address 172.168.1.222 is connected
to the core switch, Switch B. On Switch A, ports 1/0/1 and 1/0/2 are monitored by the NMS;
port 1/0/3 is connected to Switch B. And port 1/0/3 and the NMS are able to reach one
another.
Figure 6-1
Network Topology
Gi1/0/1
NMS
Switch B
Switch A
IP: 172.168.1.222
Gi1/0/2
Gi1/0/3
Demonstrated with T2500G-10MPS, this chapter provides configuration procedures in two
ways: using the GUI and using the CLI.
6.4 Using the GUI
Configuring Rate Limit on ports
Configure the rate limit on required ports. For detailed configuration, please refer to
Configuring SNMP
1) Choose
SNMP > SNMP Config > Global Confi
g to load the following page. Enable
SNMP, and set the Remote Engine ID as 123456789a. Click
Apply
.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
